Advertisement
Hold the tool by insulated gripping surfaces when performing
an operation.
Use firm pressure when drilling, but do not press too hard. Too
much pressure will not help the process and will cause the bit to
overheat, may cause the bit to bend or break, cause undue strain
on the tool, and may damage the bit or work piece. Pressing too
hard may stall the motor.
Wear ear protectors when drilling. Exposure to noise can cause
hearing loss.
Always wear safety goggles or eye protection when using this
tool. Use a dust mask or respirator for applications which
generate dust.
Secure the material being drilled. Never hold it in your hand.
Unstable support can cause the drill bit to bind, causing loss of
control and injury.
Place the switch in the locked or 'OFF' position before making any
assembly, adjustments or changing accessories. Such preventive
safety measures reduce the risk of starting the tool accidentally.
Position yourself to avoid being caught between the tool. When
the bit become jammed in the work, the reaction torque of the tool
could crush your hand or leg.
If the bit becomes bound in the work piece, release the trigger
immediately, reverse the direction of rotation and slowly press the
trigger to back out the bit. Be ready for a strong reaction torque.
Do not use dull or damaged bits and accessories. Dull or
damaged bits have a greater tendency to bind in the work piece.
Do not grasp the tool or place your hands too close to the spinning
drill chuck or drill bit.
When installing a drill bit, insert the shank of the bit well within
the jaws of the chuck. If the bit is not inserted deep enough, the
grip of the jaws over the bit is reduced and the loss of control
is increased.
When removing the bit from the tool avoid contact with skin and
use proper protective gloves when grasping the bit or accessory.
Accessories may be hot after prolonged use.
ELECTRIC DRILL SAFETY WARNINGS
6
IBL ED 10-30|06-91
Advertisement
