Platinum Control - Quadra Bigfoot User Manual

Platinum Control

("PC" part #'s)
Panel Operation Manual Version C
Operation on next page, but here are some Platinum Panel operational notes...
System typically connected to the RV "house" batteries.
The POWER, START and RETRACT ALL buttons have a 1-2 second hold time for safety (in case button was un-
intentionally bumped).
The START function (jacks automatically deploy) and EXTEND mode are disabled when the ignition is on for
safety. The RETRACT features still work in case need to use engine to boost battery voltage when ready to
leave.
The panel will shut off automatically after 10 minutes when there are no buttons pressed.
The panel will turn on automatically when the ignition is on, and will not power off until the ignition is off.
The panel will shut off automatically after 10 minutes from the ignition is shut off.
If all the LED's flash for one second and the panel turns off, the panel is receiving less than 9.5 Volts and you
need to charge your house batteries.
If the "All Up" LED is flashing after you press RETRACT, then one or more of the cylinders did not get retracted,
just press RETRACT one more time, once the "All Up" LED comes on solid all cylinders are safely retracted. Still
do a visual check for safety.
If using the manual modes, example RETRACT mode, it is better to level by bringing the vehicle/trailer UP not
DOWN. Recommend only use EXTEND mode manually.
CAUTION WHEN OPERATING:
Rear tires must maintain contact with the ground as the bolt-on system is not
designed for this and the jacks may shift. Front tires are typically OK to leave the
ground, as they may need to do so to level.
8