Programming Mode Or “All Lights Flashing On Panel”; To Program Level Position - Quadra Bigfoot User Manual

Programming mode or "all lights flashing on panel"
When all the lights are flashing on the panel, this means the control is in programming or zero mode. This is where the
user sets the level program in the controller. When the panel is first installed or hooked to power, it will enter this mode
automatically. To quickly get out of this mode (if program
has already been set) just press the POWER button or
EMERGENCY RETRACT button to shut panel off.

To Program Level Position

If all lights are flashing move to step 3.
1. Make sure all four cylinders are retracted, if they
are move to step 2. If not, turn panel ON, let diagnostic lights flash until they stop (within 30 seconds).
Press RETRACT button, when all up light comes, move on.
2. Enter zero or programming mode by turning the panel on, diagnostic lights will cycle, then press FRONT
RIGHT (top button over Bigfoot logo) button five times, then REAR LEFT button five times (not too fast or
too slow, standard second count).
3. All lights will come on, you are in zero mode. Press and hold each cylinder button (Ex. FRONT RIGHT)
individually until the cylinder touches the ground, then STOP. Run the next cylinder, press and hold, stop
once it touches the ground.
Keep in mind to avoid
twisting RV body with
individual adjustments.
4. Once all four are on the ground, you must choose a level reference point. This is where the controls will
level to on your vehicle. Examples include corner of counter top near controller, floor just in front of step,
etc. But you must only choose one spot. Place a bubble level on the reference point of the vehicle you
want to level, Example: floor in front of the entry step. Place level so it is reading front to rear.
5. Find the low end and extend the corresponding cylinders individually until the bubble reads level front to
rear, you can do small increments individually or in pairs, make sure you let coach settle before continuing
to lift (coach will shake). Once bubble level is level front to rear do the same for left to right. Keep in mind,
when programming you want to use as little of cylinder travel as possible.
6. Once level in both directions, verify that all four cylinders are touching the ground, if not bump a cylinder,
re-check level. If satisfied, next step.
7. Press the RETRACT button three times, this stores the program. Wait until the Bigfoot icon LED comes on
(AIR DUMP light will flash, just wait). Once the foot light comes on, press RETRACT to retract cylinders. If
you do not want to store program, just turn panel off or press EMERGENCY RETRACT.
8. Panel is now programmed, now every time you press AUTO it will come to this position. Can always be re-
programmed. If loss of power occurs or sensor is unplugged, sensor will still have program stored.
4
FRONT indicator operates the right front.
RIGHT operates the right rear.
REAR operates the left rear.
LEFT operates the left front.