Retract System - Quadra Bigfoot User Manual

Retract System:

1.
Press & hold the POWER button for one to two seconds
next to the button.
2.
Press & hold the RETRACT ALL button for one to two seconds, then release.
pump engage. This will run the pump until the green "All Up" light comes on constant. This process will take up
to 60 seconds. After 60 seconds the green light will flash, this means that one or more of the jacks did not fully
retract. In this case, simply press RETRACT button one more time, make sure the LED goes constant before
traveling (still recommend doing a visual check). If you have a false all up light (one or more jacks are not fully
retracted and the light is on, you may have defective limit switch) to retract override, press RETRACT, then press
& hold the corresponding button for that particular jack (version B or later only).
3. Press & hold the POWER button for one to two seconds to turn the panel off
will automatically shut off after 10 minutes of no activity or press POWER button, LED will go off.
Hear an alarm?
like a seat belt beep). This will occur until you shut the engine off or the ALL UP light turns on. This is done by
going in RETRACT mode and pressing all four buttons (one at a time) for a few seconds to see if the alarm
shuts off. This can be done with the engine on. If the ALL UP light does not come on, visually inspect each
cylinder and limit switch as there may be a defective limit switch, bent limit switch pin, loose footpad, etc.
Always do a visual check to verify that all the jacks are fully retracted prior to operating the vehicle. If one or
more cylinders are not fully retracted, you may have a defective or jammed limit switch. Go into RETRACT
mode, and press and hold that particular cylinder until it has retracted (you will hear the pump change
tone).
Platinum systems come with a one year limited warranty. If you ever have any questions or issues please
feel free to call and speak with someone in tech support at Quadra Manufacturing, 800-752-9815.
10
If the ignition is ON and the ALL UP light is OFF, the panel will sound an alarm (sounds
to turn the panel on, the red LED will come on
You will hear the
.
The panel