Assemble And Mount To Tilt Bracket - Primex OneVue Sync B100 Install Manual

Assemble and mount to tilt bracket

NOTE
Hardwired (pigtail) install: AC-powered clocks are supplied with a power cord with a two-prong plug.
The two-prong plug may be removed for a hardwired (pigtail) installation. Hardwired installation
requires a 120V~ power line in a junction box installed by a licensed electrician. Leave a minimum of 6
in. (15 cm) of cord inside the junction box. The tilt bracket has a center pass-through hole for the 120V~
pigtail. If a junction box is present, the tilt bracket has mounting holes spaced to allow direct
attachment of the tilt bracket to the junction box cover plate screw holes.
1. Mount the tilt bracket directly to the wall with the four #10 screws and anchors (supplied). To determine the
spacing of the screws, refer the mounting dimensions.
2. Latch the clock onto the tilt bracket. The top latch position determines the tilt degree.
Page 9