Table of Contents
Advertisement
Assemble and mount a dual-sided digital clock/timer
1.
On the wall or ceiling, measure and drill holes with the correct spacing to mount the flange over the junction box.
2.
Attach the flange to the wall or ceiling using the toggle anchors and the longer machine screws provided.
Wall-mount: if the mounting location is outside of the junction box, break off or cut openings in the flange to route
power cords.
3.
Attach the bracket to the flange using the supplied shorter machine screws, nuts, and washers.
4.
For wall mount only, knock out power cord break.
5.
Wire clocks to main power, using cord retaining clips to dress wires.
6.
Align the clock to the bracket hooks and hinges and snap into place.
When a clock or repeater is powered-on, it enters Add a Clock Mode to initiate a connection to the Sync Bluetooth mesh
network.
Page 14
Advertisement
Table of Contents
