Emerson Rosemount 5900S Quick Start Manual page 15

March 2020
Procedure
1. Put the O-ring on the flange and insert the Flange Ball into the hole.
Make sure that the guide pin on the side of the Flange Ball fits into
the recess on the flange.
2. Tighten the nut so that the Flange Ball fits tightly to the flange
(torque 50 Nm).
4.1.2 Mounting the welded Flange Ball
Follow this instruction when installing the welded Flange Ball on a flange.
Prerequisites
For horizontal mounting according to requirements in chapter
antenna
mm.
Quick Start Guide
A. Flange Ball
B. Nut
requirements, make sure that the diameter of the hole is 116 ± 2
Quick Start Guide
Parabolic
15