Table of Contents
Advertisement
WARNING
Risk of injury and damage to the product from
inappropriate cleaning!
Do not use high pressure washers, abra-
sive cleansers, abrasive sponges or sol-
vents such as alcohol or naphtha.
Do not support yourself on the product or
parts of the product.
4.2
Care instructions
To ensure the longest possible life, we rec-
ommend you clean the surface of the product
regularly or at least once a year.
If the first cleaning takes place years after
initial installation, the product cannot be re-
turned to its original condition.
Replacement claims cannot be honoured on
the grounds of these cleaning and care in-
structions because the effectiveness of these
measures depends on a large number of fac-
tors that vary from case to case.
Perform a functional check with the product. Watch
the product as it travels the full range of movement
and look out for any unusual behaviour or noises.
Clean the product regularly (see "Cleaning proce-
dure" table).
Fully extend the drop-arm awning when doing so.
Cleaning procedure
Wash the fabric with a mild detergent solu-
tion (water max. 30°C). A special waterproof-
ing agent has been applied to acrylic fabrics.
This waterproofing layer is diminished every
time the fabric is washed.
Clean the surfaces with a suitable cleaning
agent.
Remove dirt or objects from the product.
Fallen leaves create the conditions neces-
sary for microbial activity.
Use a clear rubber eraser to rub dirty marks
off the fabric.
Brush off the fabric (only for coated polyester
fabrics).
[B866589_3] - EN / 05.04.12
Inspect the operating elements and fabric for visible
wear and damage.
Check the substructure for damage.
Perform a functional check with the product. Watch
the product as it travels the full range of movement
and look out for any unusual behaviour or noises.
Have any damage repaired by a qualified specialist
as soon as possible. Retract the awning and take it
out of service.
4.3
Maintenance instructions
The product must be maintained regularly or
at least once a year.
Inspection and maintenance work is only to
be carried out by an appropriately qualified
specialist. We recommend you take out a
maintenance agreement with a qualified spe-
cialist.
The WAREMA warranty becomes invalid if
the unit is not cleaned properly at least once
a year.
DANGER
Risk of injury through irregular maintenance!
Page 11 of 16
Care/maintenance
Check the product regularly for signs of
wear and damage, e.g. on the motor line.
Do not use products in need of repair. In
this case, move the products to the upper
limit position and take them out of service.
Subject to change without notice.
Advertisement
Table of Contents
