Configure The Stg - WaveWare STG Manual

Note: If the STG is configured with DHCP disabled and the IP address assigned to the STG is incompatible
with the LAN that the STG is connected to, when you click the the record of the discovered STG, a popup
window will occur that tells you that you need to reset the STG to DHCP mode.
Note: The STG ships with DHCP enabled. If the LAN that the STG is connected to does not allow UDP
broadcast packets, then the WaveWare Discover and Reset Tool will not discover the STG. Refer to
Troubleshooting section for how to address this issue.

Configure the STG

Once you click on the discovered STG, if there are no IP address configuration problems, you should be
prompted for user name and password in the default browser. The default user name value is
and the default password value is
STGpass1234
A successful login will cause display of
the STG main page in the browser.
admin