Table of Contents
Advertisement
Specifications
•
Intel NUC computer, with an AC/DC power adapter
•
Linux operating system
•
4 GB RAM
•
32 GB solid state drive
•
Ethernet port
•
4 USB ports
•
Belkin USB-to-Serial Portable Adapter, as required, per serial port connection
Installation
To install the STG, you may need the following:
•
Rauland Responder 5 or Rauland Responder 5000 Server on same LAN as STG. Responder 5 and
Responder 5000 will be referred to interchangeably in this document as Responder.
•
Brekeke SIP Server™ on same LAN as STG
•
Configure Responder and Brekeke SIP Server per Rauland instructions. You will find a suggested
Brekeke SIP Server Dialplan information below.
•
Windows PC running the WaveWare Discover and Reset Tool, connected to LAN, for purposes of
discovering the STG on the LAN (only required if using DHCP to assign an initial IP address to the
STG, or if the static IP address is incompatible with the LAN the STG is connected to.
•
An Ethernet controlled paging system and/or up to four serial port controlled paging systems or
downstream devices that process TAP protocol. Note: When connecting WaveWare paging
systems to the STG USB ports, you will need a Belkin USB-to-Serial Portable Adapter for each
paging system.
•
UPS (uninterruptible power supply). A UPS can reduce the instances of potential disk corruption
or disk cleanup processes that might be required after a sudden loss of power event.
The STG should be installed using the following procedure:
•
Before powering up the STG, make all of the connections, including:
o Ethernet
o One Belkin USB-to-Serial Portable Adapter per serial port connection
•
Power up the STG. Wait a few minutes for the STG to boot up. The STG is designed to boot up
automatically when power is applied. The boot up method is adjustable in the BIOS, which is
documented in the Troubleshooting section.
Configure Static IP Address
The STG ships with DHCP enabled, so that it can obtain a dynamically assigned IP address when it is
connected to a LAN. The STG requires a static IP address assignment in order to have uninterrupted
operation monitoring the Responder alerts. Use the following procedures to set a static IP address in
the STG.
Advertisement
Table of Contents
Troubleshooting
