Resetting An Stg From Discover And Reset Tool - WaveWare STG Manual

NOTE: Pressing the STG power button, to cause a restart or shut down during a startup process, could
cause a compounding effect that may cause the STG to become unrecoverable. Avoid pressing the STG
power button during startup and shutdown cycles.
If you are unsure about what state the STG is in after initiating a startup or shutdown cycle, you can
connect a monitor to the STG's HDMI port and be able to directly configure the STG.

Resetting an STG From Discover and Reset Tool

If the STG is configured with DHCP disabled and the IP address assigned to the STG is incompatible with
the LAN that the STG is connected to, when you click the the record of the discovered STG, a popup
window will occur that tells you that you need to reset the STG. Resetting an STG primarily enables
DHCP mode in the STG and restarts the STG.
To reset an STG, click on the reset button (gear icon). A Reset WaveWare Systems window will appear.
Click on the Reset STG Settings button. A Reset STG window will appear.
Follow the instructions in the Reset STG window. Note: You will require both a Belkin USB-to-Serial
Portable Adapter and a null modem adapter to enable the PC
to STG serial port connection.
When the Reset button is clicked, if the STG is reset
successfully, a popup window will appear indicating success.
Once you have successfully reset the STG, and have waited at
least one minute for the STG to restart, you can click Cancel,
then Exit, and return to the main Discover and Reset Tool
screen and try the Discovery process again.