In The Event Of Problems - Rowenta PROCERAM SO9020F0 Manual

Hide thumbs

Table Of Contents

Table of Contents

Available languages

NOT SO9020 CD050131

15/05/06

Select the Operating mode.

Press the

button on the control panel for 2 seconds.

On the control panel:

- The

function indicator flashes.

- The MODE indicator you have selected lights up.

You can see on the display screen:

- The operating mode you have selected.

- The

symbol flashing.

Note: If you do not define a time, the function will be cancelled after a few seconds.

To define the operation time (for

You can see on the display screen:

- The operating mode you have selected.

- The

symbol flashing with the times selected.

For

: to confirm the setting, press the

For

: to confirm the setting,

- press the

button

- or press the

button (2 seconds) to add an operation time, then press the

On the control panel:

- only the

or (and)

function indicator is lit up.

You can see on the display screen:

- The operating mode you have selected and the

Note: For

, if the

button is not pressed to confirm, the function will be cancelled after a few seconds.

TIMER Function:

The appliance operates in the MODE you have chosen and for the length of time defined in

It is possible at all times:

- To stop the appliance (by pressing

- To change the operating mode.

PROG Function:

The appliance will be started later at the number of hours you have defined in

of time defined in

, if this function has been programmed).

It is possible at all times:

- To start the appliance or stop your programme. (by pressing

Display on screen:

The times displayed on the screen are:

- For the

function: the number of hours remaining before the appliance will start.

- For the

function: the number of hours of operation remaining.

The countdown on the display is in steps of one hour, at the end of the hour that has passed.

Oscillation Function:

1/ Press the

button on the control panel or the remote control.

The appliance oscillates angularly through 90°.

On the control panel:

- The oscillation function indicator lights up.

2/ Press the

button on the control panel or the remote control again.

The appliance will stop oscillating.

7- CLEANING

• Your appliance must be switched off using the ON / OFF switch located at the base, unplugged and allowed to cool before any cleaning is carried out.

• You can clean it with a slightly damp cloth.

• Important: Never use abrasive products which might damage the appearance.

• Your appliance is fitted with a removable and washable dust filter (fig. 1+ 6 – H) (warm water and soap) which has to be cleaned regularly (fig. 5a+5b).

• Always ensure that the filter is dry before fitting it.

• Never use the appliance without its filter.

8- STORAGE

• It is important that the appliance be allowed to cool down before it is put away.

• When you are not using the appliance, store it in a dry place.

• If it is to be stored for a long period, remove the batteries from the remote control.