For Your Safety - Hazet 4934-3478/11 Operating Instructions Manual

1. owner's Liability
This tool set was developed and man­
ufactured according to the technical
norms and standards valid at the time
and is considered to be operationally reliable.
Nevertheless, the tool set can present a dan­
ger when it is not used as intended or in an
inappropriate way by non­qualified personnel.
Please make sure that any person using this
tool set or carrying out maintenance work
reads these operating instructions carefully
and understands fully all information given,
before using the tool.
• Keep the operating instructions together
with the tool set at all times.
• Any modification of the tool set is strictly
forbidden.
• All security advices, warning and operation
notices on the tool set have to be kept leg­
ible. Replace all damaged labels or stickers.
• All indications concerning setting values
and setting ranges must be observed.
2. Appropriate use
Operational reliability can only be
ensured, if the tool is used as intend­
ed and in compliance with the indica­
tions given in the operating instructions.
In addition to the safety advice given in these
operating instructions, the general safety regu­
lations, regulations for the prevention of acci­
dents and for environmental protection being
valid for the application area of the tool set
have to be observed and respected.
Always ensure tools are used, inspected and
maintained in compliance with the respective
local, state, national or federal regulations.
• The tool set must only be used if it is in good
conditions.
• All safety equipment must always be within
reach and should be checked regularly.
• The tool set is intended for dismounting/
assembling wheel hubs / wheel bearings on
passenger cars. See list at the right side of
this page.
• The tool set is only intended for manual use.
• Any deviation from the intended use and/
or any misapplication of the tool set is not
allowed and will be considered as improper
use.
12
b
For Your Safety
During operation do not reach into extractor device!
Lubricate the threaded spindle 4930-1 before each use!
• Any claims against the manufacturer and/
or its authorized agents because of damage
caused by improper use of the tool set will
be void.
• Any personal injury or material losses caused
by improper use are the sole responsibility
of the owner.
• Prior to each use lubricate the threaded
spindle 4930­1.
• During operation of the threaded spindle
do not reach into the extractor device oth­
erwise there is a risk of severe injury!
• Classification to vehicles:
Vehicles with wheel bearing x 78 mm
(with stud bolts)
FORD
Focus 2
C-Max
VOLVO
C 30
C 70 2 Cabriolet
S 40
V 50
MAZDA 3 (BK)
1.4 - 1.6 - 1.6D TurBo since 2003
Expansion Set 4934-3482/6 up to x 82 mm
FORD
Focus 2
Focus 2.5 rS
Focus 2.5 rS 500
Mondeo 4
since 2004
years 2003-2007
since 2007
since 2006
since 2006
since 2004
since 2004
since 2007
since 2007
since 2007
since 2007