Table of Contents
Advertisement
5.0 Operating Modes
5.2.3 Preset
The current measurement is forced to a preset value and all subsequent measurements are taken fro this preset value. Preset can be applied either from
the WHT buttons or from the controller. To use the WHT button the button state must be first set up – see section 5.4 below on Button allocation. Preset can
only be cleared from the controller.
5.2.4 Scaling
The measurement from the WHT may be scaled by a multiplication factor. The scaling can only be set or cleared from the controller software
5.2.5 Max (Peak+)
The WHT can be set up so that the most positive measurement is displayed. This can be set up only from the controller. The MAX (PEAK+) can only be
reset from the controller.
5.2.6 Min (Peak-)
The WHT can be set up so that the most negative measurement is displayed. This can be set up only from the controller. The MIN (PEAK-) can only be
reset from the controller
5.2.7 Diff
The WHT can be set up so that the difference between MAX and MIN is transmitted. This can be set up only from the controller. The DIFF can only be reset
from the controller
All of the above modes are either continuous transmission or on a button press.
5:0 Operating Modes
8
502848 Issue 5
Advertisement
Table of Contents
