Table of Contents
Advertisement
3.0 Mechanical Adjustments
Once the gauge head has been installed its rotational position can be adjusted by approximately 180º about the mounting axis.
1. Using a 3 mm A/F Hex key, undo the M6 grub screw pictured above.
2. Rotate the gauge head to the desired position.
3. Tighten the M6 grub screw to a recommended 1.3-1.5 Nm torque.
Note
Large gauge heads may require a higher torque setting on the grub screw to prevent rotation through use.
Caution
Care must be exercised when using a large gauge head to avoid damaging the grub screw or WHT.
3.0 Mechanical Adjustments
USE 3 mm A/F ALLEN KEY
FOR M6 GRUB SCREW
TORQUE SETTING 1.3-1.5 Nm
5
502848 Issue 5
Advertisement
Table of Contents
