Charging The Wht Or Battery Pack - Ametek Solartron Metrology Wigauge WHT User And Installation Manual

Wireless handtool
Hide thumbs Also See for Solartron Metrology Wigauge WHT:
Table of Contents

Advertisement

6.0 Battery Pack

6.3 Charging the WHT or battery pack

The battery pack may be charged either removed from the WHT or in situ. Plug the charger unit into the connector at the top of the battery pack. Remove the
cover if necessary.
Switch on the charger, initially an orange indication is shown, which will turn to yellow once the charger begins an initialization process. After a few seconds
this will then change back to orange once charging starts.
After the main charge cycle has finished the indicator will be green with intermittent yellow flashes. Do not disconnect the batteries at this point as they are
not fully charged. When the indicator is green charging is complete and the charger will be in trickle mode.
Caution
Use of chargers other than those recommended by Solartron may invalidate product warranty and may damage the battery pack and WHT.
Recommended Charger Types:
Solartron 911441
6.0 Battery Pack
14
502848 Issue 5

Advertisement

Table of Contents
loading

Table of Contents