Table of Contents
Advertisement
5.0 Operating Modes
5.1 Data Transmission
5.1.1 Streaming
In this mode the WHT continually sends data to the controller. The stream rate can be adjusted.
If a button is pressed in this mode the measurement being taken at the time the button is pressed is tagged.
This tagged data can be captured by the controller.
5.1.2 Single Shot
Tagged data is sent each time the button is pressed
Note the button must be set to the correct state to ensure tagged readings are sent, this is the normal or default mode, but it is possible to set the buttons to
other modes – see section 5.4 below on Button allocation.
5.2 Measurement Types
The WHT can be set to measure in different modes, these are;
5.2.1 Absolute
The WHT transmits the absolute value of the measurement.
5.2.2 Zero
The current measurement is forced to zero and all subsequent measurements are taken from this zero. Zero can be applied either from the WHT buttons
or from the controlling software. To use the WHT button the button state must be first set up- – see section below on Button allocation. Zero can only be
cleared from the controller.
5:0 Operating Modes
7
502848 Issue 5
Advertisement
Table of Contents
