Advertisement
Replacement Procedure
(8) Replacement of Remote Control
1, Take off the arm rest (right) and the cover
(arm rest lower right).
2, Disconnect the connector of remote control
cord around the power supply box.
3, Remove eight remote control case set screws
and take off the remote control case (lower).
Remote control case set screws
Remote control case (lower)
4, Remove three PCB (remote control) set screws
and remove the latches of five ribs.
5, Take off the PCB (remote control).
6, Disconnect the interconnecting connector
CN301 of the remote control cord.
PCB (remote control)
Remote control cord
Photo-1,2
Photo-14
Remote control cord
Photo-14
Photo-15
Photo-15
Photo-15
PCB set screws
CN301
Photo-15
- 28 -
(9) Replacement of Sensor Controller
1, Take off the arm rest (right) and the cover
(arm rest lower right).
2, Take off the power supply box.
3, Take off the case (power supply box upper)
and disconnect the connector (sensor A).
4, Remove four sensor case set screws and
take off the sensor case (upper).
Sensor case
set screws
5, Remove one PCB (sensor controller) set
screws.
6, Take off the PCB (sensor controller) and
disconnect the connectors (CN701, CN702
and CN703) connected to the PCB (sensor
controller).
CN701
PCB set screw
CN703
HEC-DR8700
Photo-1,2
Photo-11,12
Photo-12,13
Photo-16
Sensor case (upper)
Connector (sensor A)
Photo-16
Photo-17
Photo-17
PCB (sensor controller)
CN702
Photo-17
Advertisement
