Sanyo HEC-DR7700 Instruction Manual

Chair type massager

Hide thumbs Also See for HEC-DR7700:

Service manual (29 pages)

Service manual (28 pages)

Table Of Contents

Summary of Contents for Sanyo HEC-DR7700

Page 1 Be sure to read this manual thoroughly in order to ensure proper use. In particular, make certain to read the section "IMPORTANT SAFETY INSTRUCTIONS". SANYO Electric Co., Ltd. Keep this manual in a safe place so that it can be found easily. OSAKA, JAPAN...
Page 2: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS All of the following information is important. Be sure to follow the instructions carefully. When using an electrical appliance, basic precautions should always be followed, including the Do not wind the power cord, remote control cord or sensor controller cord around the main unit, following: remote control, sensor controller, or remote control stand.
Page 3 IMPORTANT SAFETY INSTRUCTIONS WARNING Do not use the massager on bare skin. Otherwise, an injury may occur. Be careful not to spill water over the remote control, sensor controller, seat, or foot rest. Do not use for any other purposes other than as a massager or as a chair. Otherwise, electric shock, short circuit or fire may occur.
Page 4: Name/Function Of Each Part
NAME/FUNCTION OF EACH PART Remote control HOME POSITION button Used to return the back rest, foot rest and seat to Head cover their home position. Åñ All display icons are shown here Seat for explanation. ZERO-G button Used to adjust the back rest, foot rest and seat to Sensor controller the two preset types of reclining angle.
Page 5 NAME/FUNCTION OF EACH PART Positions that can be massaged. PRESSURE display How to move the massager Positions where stiffness has been detected. Displays the strength of the pressure on the body (the pressure from the massaging rollers). Raise the back rest. Raise the front side of the Shoulder position measurement / STIFFNESS display...
Page 6: How To Install The Stand
HOW TO INSTALL THE STAND Installation on the right-hand side of the arm rest Installation on the left-hand side of the arm rest Tools needed: Phillips (crosshead) screwdriver, flathead screwdriver (Åñ screwdrivers are not included) Tools needed: Phillips (crosshead) screwdriver, flathead screwdriver (Åñ screwdrivers are not included) Remove the cover of the right-hand Put the remote control on the Remove the covers on the outer...
Page 7: How To Use
HOW TO USE PREPARATIONS PRIOR TO USE The procedure for use of the massager is explained here. See the referred pages for details. WARNING Check the cloth of the chair. Prior to use, be sure to raise the back pad The following persons are requested to consult a Prior to use, make certain to read the "IMPORTANT SAFETY INSTRUCTIONS".
Page 8: Adjustment Of Chair
ADJUSTMENT OF CHAIR Before sitting on the massage chair Press ZERO-G button to move the back rest, foot rest, and the seat to achieve the desired Bring all parts of the massage chair to Foot rest reclining position. Press their home position by pressing the HOME POSITION button.
Page 9 ADJUSTMENT OF CHAIR MASSAGING (WHOLE BODY SENSOR AUTOMATIC COURSE) Adjust the angle of the foot rest. Press the OPERATION ON/OFF button. WARNING When the button is pressed, the lamp of the remote control Angle adjustment can be made for illuminates and the sole warmer will turn on. When the foot rest is suddenly released foot rest only.
Page 10 MASSAGING (WHOLE BODY SENSOR AUTOMATIC COURSE) Measurement of shoulder position Massaging operation and display of remote control Starts massaging automatically. Displays the aim of massaging positions, the type Measure the position of shoulder and Ö@ Measure the position of shoulder. of massaging, the stiffness, body pressure and the match the position of massaging rollers Check if the position of shoulder is correct.
Page 11 MASSAGING (AUTOMATIC COURSE) Measurement of shoulder position Massaging operation and display of remote control Press the OPERATION ON/OFF button. Displays the aim of massaging positions, the type When the button is pressed, the lamp of the remote Measure the position of shoulder and of massaging, body pressure and the remaining control illuminates and the sole warmer will turn on.
Page 12 MASSAGING (MANUAL COURSE) Massaging of upper body Press the MANUAL button. MANUAL button Press the desired MANUAL (UPPER BODY) MASSAGING button. Refer to page 23 for details of the contents of massage. For grasping shoulder massaging and spine stretching, measure the position of shoulder at first.
Page 13 MASSAGING (MANUAL COURSE) Kinds of massages and adjustments of massaging rollers Massaging of lower body 20 types of desired massage can be selected. Simultaneous massaging of any part of "upper body" and "lower body (air)" is possible. It is possible to adjust the movement speed, height position and width of massaging rollers and the strength of massage. Individual massaging of "upper body"...
Page 14: After Use
WHEN THE MASSAGE IS FELT TO BE STRONG (WEAK) AFTER USE CAUTION When the massage is felt to be strong After use, be sure to set the POWER switch to the [OFF] position, and the LOCK switch to the Use the massager by putting a towel, etc., [LOCK] position.
Page 15: Contents Of Massaging
Åñ The drawing of the massage for each course is omitted in part, in order to describe the CONTENTS OF MASSAGING operation in a simplified manner. Also, the drawings of air massage operation for lower body are all omitted. WHOLE BODY SENSOR AUTOMATIC COURSE WHOLE BODY SENSOR AUTOMATIC COURSE Åq År...
Page 16: Troubleshooting
TROUBLE-SHOOTING SPECIFICATIONS WARNING Power consumption 290 W If the trouble still persists even after the following the proper countermeasures have been taken, stop using the massager to avoid possible accidents. Disconnect the power plug from the outlet and consult the sales agent. Power dissipation of electric heating equipment 33 W Do not attempt to repair the equipment at home by yourself, as it is very dangerous.

Sanyo HEC-DR7700 Instruction Manual

Table of Contents

Related Manuals for Sanyo HEC-DR7700

Summary of Contents for Sanyo HEC-DR7700

Table of Contents