Advertisement
Motor/Stress Sensors Operation Confirmation Procedure
Start-up of Examination Mode
Turn ON the POWER switch at the rear of the massager while simultaneously pressing the
ROLLER POSITION "UP" and "DOWN" buttons and "STRETCH" button on the remote controller
(This operation should be started with the POWER switch turned OFF).
When the examination mode is started up, the back rest, foot rest and seat move to their
home position and come to a stop. (The back rest, foot rest and seat do not move when they
are already at the home position.)
Air-Bag Operation Confirmation
Press either "
remote controller.
Motor Operation Confirmation
Seven motors work at the same time when they push "REPEAT" button.
Massage motor and Tapping motor is fastest moves.
Elevation motor and Strength motor goes to an upper
point and lower point and return.
Reclining motor (foot rest/back rest/seat) repeat the expansion and
contraction.
Movement / a stop is possible with a "REPEAT" button again and again.
*After you exchanged the massage unit, reclining motors or PCB, confirm
the movement by this function.
When there is abnormality, the operation of the examination mode stop and display
abnormal indication, find out the problem and repair.
As for this function , the sole warmer, the air pump / the valve also move at the same time.
<Back rest>
2,
Massage motor
3
4
4,
Elevation motor
Body Pressure Sensor Operation Confirmation
"Press" on the remote control will be turned on when press the massaging rollers.
Stress Sensor Operation Confirmation
"Grip the Sensor" on the remote control will be turned off and "AUTO
illuminated when touch the sensor on one side with your fingers (hand).
Afterward, touch the sensor on other side in the same way
and confirm that "AUTO
* If there are any problems, find out the problems and repair.
To remove the examination mode, turn OFF the POWER switch.
(UP)" or "
(DOWN)" button of the LOWER BODY adjustment on the
(move for 3min)
2
2
1
3
3,
Strength motor
4
1,
Tapping motor
" will be illuminated.
<Seat under>
5. Reclining motor
(Seat)
- 23 -
HEC-DR8700
"REPEAT"
button
6. Reclining motor
(Back rest)
7. Reclining motor
(Foot rest)
" will be
display
Sensors
(Touch separately)
Advertisement
