Download Print this page

Sanyo HEC-DR8700 Service Manual page 35

Chair type massager (massage lounger)
Hide thumbs Also See for HEC-DR8700:

Advertisement

Replacement Procedure
(23) Replacement of Foot rest comp.
1, Rotate main body of the chair so the back of
the head rest is on the floor and the foot
rest is in the air.
2, Lift up the foot rest and insert a screwdriver
and so forth into the link to fix the link.
3, Remove eight cover (under) set screws and
take off the cover (under upper right), the
cover (under upper left) and the cover
(under front).
Cover (under upper) right
Cover set screws
Cover (under front)
4, Disconnect each air hose and disconnect
connector (heater B).
5, Loosen nuts of the wire (foot rest slide) and
remove the wire (foot rest slide). Photo-41
Air hoses
Wire (foot rest slide)
Nuts (wire)
Air hose joint
Mar./2010 Printed in Japan
Photo-40
Photo-40
Photo-40
Screwdriver, etc
Cover (under upper) left
Photo-40
Photo-41
Connector (heater B)
Air hoses
Connector (heater B) joint
Photo-41
6, Cut the bands and unzip the fastener between
the foot rest section and seat section.
7, After lower the foot rest, lay down the main
body with its left side facing downward.
8, Remove E rings and pull out fixing pins and
take off the foot rest.
E ring and fixing pin
Bands
Fixing pin
E ring
- 35-
HEC-DR8700
Photo-42
Photo-42
Foot rest
E ring and fixing pin
Fastener
Photo-42
Fixing pin
E ring
Foot rest
SANYO Electric Co.,Ltd
Osaka, Japan
Bands

Advertisement

loading