Zanussi ZBP 1165 Instruction Booklet page 8

To select a Cooking Function
1. Switch on the oven by touching the "ON/OFF" control
.
2. Touch the "Cooking Functions" control
the required oven function. Each time control
touched, a different cooking symbol appears in the
lower section of the display and the description of
the cooking function appears as a message in the
upper section. The pre-set temperature for each
function is shown in the lower section, and symbol
" " flashes on the right hand (Fig. 8).
3. Symbol " " flashing means that it is possible to
adjust the pre-set temperature by touching control
" " or " " (Fig. 9). Temperature level is adjusted in 5
degree steps. Please note that symbol " " will flash
for 5 seconds.
4. When 5 seconds elapse, symbol " " will come off
showing that the temperature level has been stored
in the Electronic Control memory. The thermometer
symbol rises slowly
which the oven is currently heated.
5. When the required temperature is reached, an
acoustic alarm will sound for a short time and the
thermometer symbol
To set the temperature and
time
Control " " and " " are used to adjust both the
temperature and the time settings. Details about using
them according to the different functions of the Oven
Electronic Control are given in the following chapters.
As a general rule, please note that:
> Controls " " and " " are used to increase or decrease
the temperature seetings while symbol " " flashes
on the right hand of the temperature display. When
you choose a cooking function, symbol " " keeps
flashing for 5 seconds only. This is the useful interval
to touch controls "
temperature setting. Once these 5 seconds elapse,
symbol " " comes off and the thermometer symbol
comes on: this means that the current selection
has been stored in the Oven Electronic Control
memory and that the oven is currently heating up.
> Controls " " and " " are used to increase or
decrease the time settings while the symbol
flashing near the "Clock" symbol
Minder" symbol , the "Cooking Duration"
symbol or the "End Of Cooking Time" symbol
When you choose a time function, symbol
flashing for 5 seconds only. This is the useful interval
to touch control " " or " " and select your time
setting. Once these 5 seconds elapse, symbol
stops flashing: this means that the current selection
has been stored in the Oven Electronic Control
memory.
8
to select
, indicating the degree to
will light permanently.
" or " " and select your
, the "Minute
keeps
is
is
.
Fig. 8
Fig. 9