Install The Rear Hot-Swap Drive Assembly - Lenovo ThinkAgile MX3321-H User Manual

Install the rear hot-swap drive assembly

Use this information to install the rear hot-swap drive assembly.
Chapter 4 "Read
the
installation
Guidelines" on
page 29
Before installing the rear hot-swap drive assembly, touch the static-protective package that contains the new
rear hot-swap drive assembly to any unpainted surface on the outside of the server. Then, take the new rear
hot-swap drive assembly out of the package and place it on a static-protective surface.
To install the rear hot-swap drive assembly, complete the following steps:
Step 1. Gently press and hold the tab on the rear hot-swap drive assembly as shown and remove the air
baffle from the rear hot-swap drive assembly.
Figure 69. Air baffle removal
Step 2. Connect the SAS signal cable to connector
to connector 2
100
ThinkAgile MX Certified Node 1UThinkAgile MX3321-H, MX3321-FUser Guide
for this task"
on the rear backplane.
"Power off
the server
on page 34
1
on the rear backplane and connect the power cable
"ATTENTION:
Static Sensitive Device
Ground package before opening"
on page 31