System Memory Requirements - IBM PS/2 N51 SX HMR Manual

Hide thumbs Also See for PS/2 N51 SX HMR:

Table of Contents

3.0 System Memory Requirements

The Model N51 has a minimum of 2MB of memory installed on the system board

at the time of shipment.

8MB, can be installed into the memory module connector on the system

board.

The maximum system-board memory capacity is 10MB.

If a memory error occurs, the Model N51 relocates system-board memory in

1MB blocks.

If the POST detects a memory error in the first 640KB of

system-board memory, the entire 1MB of memory is deactivated and an error

code is displayed.

Note:

Customer diagnostics is capable of logically eliminating defective

memory so that no memory error code appears at power-on reset.

After replacing a defective memory module kit, or whenever memory is added

or removed from the system, run the 5. Automatic configuration to store

the new system configuration.

Note:

If you configure the system using the 4. Set configuration from the

Reference Diskette, make sure the languages of the Reference

Diskette and the system must match.

IBM PS/2 Model N51 SX HMR

System Memory Requirements

One additional memory-module kit, 2MB, 4MB, or

3.0 - 1

Table of Contents