TLV LV6-CE Instruction Manual
Clean steam trap
Hide thumbs
Also See for LV6-CE:
- Instruction manual (14 pages) ,
- Instruction manual (32 pages) ,
- Instruction manual (17 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for TLV LV6-CE
Summary of Contents for TLV LV6-CE
- Page 1 172-65230A-06 (LV6) 23 May 2019 Clean Steam Trap LV6-CE / LV6-SF / LV6-P / LV6-EP Manufacturer 881 Nagasuna, Noguchi, Kakogawa, Hyogo, 675-8511, Japan Tel: [81]-(0)79-422-1122 Fax: [81]-(0)79-422-0112 Copyright © 2019 by TLV CO., LTD. All rights reserved...
-
Page 2: Table Of Contents
If detailed instructions for special order specifications or options not contained in this manual are required, please contact TLV for full details. This instruction manual is intended for use with the model(s) listed on the front cover. -
Page 3: Safety Considerations
The three types of cautionary items above are very important for safety: be sure to observe all of them as they relate to installation, use, maintenance and repair. Furthermore, TLV accepts no responsibility for any accidents or damage occurring as a result of failure to observe these precautions. -
Page 4: Checking The Piping
Checking the Piping Use only under conditions in which no water hammer will occur. The impact of water hammer may damage the product, leading to fluid CAUTION discharge, which may cause burns or other injury. Check to make sure that the pipes to be connected to the product have been installed properly. -
Page 5: Operation
Operation Principles of air and condensate discharge: 1. Start-up air and cold condensate discharge When the system is cold before the supply of steam, the X-element is in its contracted state and the valve is open. This allows for the rapid discharge of large quantities of air and cold condensate through the open valve, thus Valve... -
Page 6: Specifications
Specifications Install properly and DO NOT use this product outside the recommended operating pressure, temperature and other specification ranges. CAUTION Improper use may result in such hazards as damage to the product or malfunctions which may lead to serious accidents. Local regulations may restrict the use of this product to below the conditions quoted. -
Page 7: Installation
Installation Install properly and DO NOT use this product outside the recommended operating pressure, temperature and other specification ranges. CAUTION Improper use may result in such hazards as damage to the product or malfunctions which may lead to serious accidents. Local regulations may restrict the use of this product to below the conditions quoted. -
Page 8: Maintenance
Periodically the operation should also be checked by using diagnostic equipment such as a stethoscope, thermometer, TLV Pocket TrapMan or TLV TrapMan. If the product should fail, it may cause damage to piping and equipment, resulting in faulty or low quality products or losses due to steam leakage. -
Page 9: Disassembly/Reassembly
Disassembly/Reassembly When disassembling or removing the product, wait until the internal pressure equals atmospheric pressure and the surface of the product CAUTION has cooled to room temperature. Disassembling or removing the product when it is hot or under pressure may lead to discharge of fluids, causing burns, other injuries or damage. -
Page 10: Troubleshooting
Exploded View Upper Body X-element Body Clamp Gasket Wing Nut Lower Body Troubleshooting When disassembling or removing the product, wait until the internal pressure equals atmospheric pressure and the surface of the product CAUTION has cooled to room temperature. Disassembling or removing the product when it is hot or under pressure may lead to discharge of fluids, causing burns, other injuries or damage. -
Page 11: Option (2-Piece Clamp With Bolts And Nuts)
Option (2-piece Clamp with Bolts and Nuts) Configuration Name Lower Body Upper Body X-Element Body Clamp Gasket Clamp Bolt Clamp Nut 172-65230A-06 (LV6) 23 May 2019... - Page 12 Disassembly/Reassembly When disassembling or removing the product, wait until the internal pressure equals atmospheric pressure and the surface of the product CAUTION has cooled to room temperature. Disassembling or removing the product when it is hot or under pressure may lead to discharge of fluids, causing burns, other injuries or damage.
- Page 13 Exploded View Upper Body Clamp Bolt X-element Gasket Lower Body Body Clamp Clamp Nut 172-65230A-06 (LV6) 23 May 2019...
-
Page 14: Express Limited Warranty
Subject to the limitations set forth below, TLV Corporation, a North Carolina corporation (“TLV”) warrants that products which are sold by it, TLV CO., LTD., a Japanese corporation (“TLVJ”) or TLV International, Inc., a Japanese corporation (“TII”), which products (the “Products”) are designed and manufactured by TLVJ, conform to the specifications published by TLV for the corresponding part numbers (the “Specifications”) and are free from defective workmanship and... - Page 15 TRANSPORTATION COSTS ASSOCIATED WITH THE RETURN OR REPLACEMENT OF THE CLAIMED DEFECTIVE PRODUCT ARE SOLELY THE RESPONSIBILITY OF BUYER OR THE FIRST END USER. TLV RESERVES THE RIGHT TO INSPECT ON THE FIRST END USER’S SITE ANY PRODUCTS CLAIMED TO BE DEFECTIVE BEFORE ISSUING A RETURN MATERIAL AUTHORIZATION.
Need help?
Do you have a question about the LV6-CE and is the answer not in the manual?
Questions and answers