5) 2=polarity reversal protection, 3=short-circuit protection for all transistor outputs 6) These proximity switches shall be used with UL Listed Cable assemblies rated 30V, 0.5A min, in the field installation, or equivalent (categories: CYJV/CYJV7 or PVVA/PVVA7) KRTL 3B… - 06 2016/08...
The device must not be tampered with and must not be changed in any way. There are no user-serviceable parts inside the device. Repairs must only be performed by Leuze electronic GmbH + Co. KG. Leuze electronic GmbH + Co. KG In der Braike 1 D-73277 Owen Tel.
Page 4
Device in RUN mode. 7 … 12s and release. alternatingly. button. Yellow LED illuminates. 7 … 12s Value for background Alternating Value for mark is Switching threshold is is accepted. flashing accepted. set near the mark. KRTL 3B… - 06 2016/08...
Page 5
Yellow LED is off. 7 … 12s Alternating Value is accepted. High sensitivity is set. flashing Leuze electronic GmbH + Co. KG In der Braike 1 D-73277 Owen Tel. +49 (0) 7021 573-0 KRTL 3B… - 06 info@leuze.de • www.leuze.com...
Page 6
Switching output for switching threshold near the mark Static 1-point teach Label with marks Teach reference value Standard sensitivity Receive signal High sensitivity Switching output for standard sensitivity Switching output for high sensitivity KRTL 3B… - 06 2016/08...
Page 7
If the upper or lower end of the adjustment range is reached, the green and yellow LEDs flash at a considerably higher fre- quency of 8Hz for the duration of one second. Leuze electronic GmbH + Co. KG In der Braike 1 D-73277 Owen Tel. +49 (0) 7021 573-0 KRTL 3B…...
Page 8
(e.g., protection from erroneous operation or manipu- lation). If the teach input is not connected or if there is a static low signal, the button is unlocked and can be operated freely. KRTL 3B… - 06 2016/08...