Idex Knight On-Premise Pro Instruction Manual page 8

Priming the pumps:
(1) Enter the access code if you do not already have
access to the system.
(2) Ensure that the pump time LED is flashing. If the
delay time LED is flashing, press MODE to choose
pump time.
(3) Choose the pump with the PUMP SELECT button.
Use whichever of the following two procedures that
applies.

If pump run times are not yet programmed, press
CALIBRATE to manually start/stop pump.

If pump run times are already programmed, press
PRIME to activate the run time for the pump and
formula presently selected. This can also be used to
verify if the programmed run time will dispense the
correct formula volume. Press RESET if the pump
must be stopped during this prime function.
Calibrating pump run times:
For this procedure, you will want to use a suitable
container that has volume markings, such as a beaker,
or graduated cylinder.
(1) Ensure the pickup and delivery lines are primed.
(2) Enter the access code if you do not already have
access to the system.
(3) Ensure that the pump time LED is flashing. If the
delay time LED is flashing, press MODE to choose
pump time.
Page 8 of 20
(4) Choose the desired pump and formula using their
respective SELECT buttons.
(5) Position your container below the output of the
pump you selected, then press CALIBRATE. The
pump will run and the 3-digit display will begin
counting.
(6) When you have reached the desired volume in your
container, press CALIBRATE again. The pump will
stop, and the 3-digit display will show the time it
took to pump the volume.
(7) Press ENTER and the display will flash briefly,
indicating that the pump time was accepted.
Manually programming pump run times:
(1) Enter the access code if you do not already have
access to the system.
(2) Ensure that the pump time LED is flashing. If the
delay time LED is flashing, press MODE to choose
pump time
(3) Choose the desired pump and formula using their
respective SELECT buttons.
(4) Use / to input a new pump time or to change an
existing pump time (if a pump time is already
programmed, it will show up in the 3-digit display
when you press /).You can hold down on the
arrow button if you wish to rapidly advance the
numbers.
(5) Press ENTER and the display will flash briefly,
indicating that the pump time was accepted.
0901133 Rev: A (11/13)