Open Windows Function; Optimizer Energy Plus Technology; Installation And Mounting - Rointe Sygma SRI0330RAD2 Instruction Manual

SYGMA

1.8. OPEN WINDOWS function

This function is activated when the temperature sensor detects a drop of 4ºC from the set temperature
within a 30 minute time period. The OPEN WINDOWS function will be active for 2 hours. If the
button is pushed during this period the product will switch off. Pushing the button
switch on the product without the OPEN WINDOWS function being switched on.
When this function is activated by the sensor, the following image will appear on the product display
panel for 5 seconds:
When the OPEN WINDOWS function is activated, the product will move into ANTI-FROST mode at
8ºC. The icon will appear on the product display panel showing that the ANTI-FROST mode is
active.

1.9. Optimizer Energy Plus technology

Optimizer Energy Plus is a technology developed by Rointe that bases its operation on thousands of
micropulses being sent to the product to keep a stable temperature with a consumption as low as
possible. When the
el, then the Optimizer Energy Plus technology has been activated and is working.

2. Installation and mounting

2.1. Mounting instructions
The product must never be installed directly below a power point. In bathrooms, the product must
never be installed where the switches and/or other products may be within the reach of someone in
the shower or bathtub.
The product works using natural air convection (Figure 1). In order to achieve optimial performance
and an even distribution of heat, the product must be positioned according to the following table
(Table 1). See Figure 2 for positioning.
Table 1:
MINIMUM (cm)
PRODUCT
PART
Lower
Sides
Upper
6
icon on the display panel is replaced with the
MAXIMUM (cm)
DISTANCE FROM FLOOR / WALL /
BRICKWORK
10 - 12
10 - 12
10 - 12
30
-
-
again will
icon on the display pan-