Pan Id Setup - Honeywell MBeacon User Manual

8.2.1 PAN ID Setup

All units on a network must be programmed with the same PAN ID
(Personal Network Identifier) to ensure communication compatibility.
When you see this screen, press [MODE] to view the current PAN ID or
to change it:
Important! The allowed range for PAN ID numbers is 001 through 999.
The screen shows the PAN ID, with the cursor blinking on the first digit.
Step through the digits from left to right by pressing [MODE]. Change a
digit's value by pressing [Y/+] to increase and [N/-] to decrease. After
the third digit, you see a flashing "?"

Save your changes by pressing [Y/+].

Exit without saving changes by pressing [N/-].

Step back to the first digit by pressing [MODE].
Note: If you do not press a key within 60 seconds, the screen reverts to
the programming Menu screen showing Settings, Modem, and Exit.
MBeacon User's Guide
24