Texas Instruments TI-Nspire CX II Series Handhelds Manualbook page 83

Shown
Message and Description
on
Sending
handheld
This message is displayed if a cable is not attached to the sending handheld's
link port. Remove and then reinsert the cable and try the document
transmission again.
Click OK to cancel the transmission message.
Note: The sending handheld may not always display this message. Instead, it
may remain BUSY until you cancel the transmission.
Sending
"Receiver does not have enough storage space for file
handheld
This message indicates that the receiving handheld does not have enough
storage to accept the file being transmitted.
The user of the receiving handheld must free space to obtain the new file. To
do this:
• Delete unneeded files.
• Store files on a computer for later retrieval, and then delete them from
the TI-Nspire™ handheld.
Sending
"<folder>/<filename> transferred as <folder>/<filename(#)."
handheld
This message is displayed at the end of a successful transfer when the file had
to be renamed because a file already exists on the receiving handheld with
the original name. The transmitted file is renamed by appending a number to
the end of the name. Rename numbering always begins with (2) and can
increment by one, as needed.
Sending
"<folder>/<filename> transferred as <folder>/<new filename>."
handheld
This message indicates that a new folder was created on the receiving
handheld to contain the transmitted document.
Receiving
handheld
This message indicates that the receiving handheld has a document with the
same name as the document being sent.
Receiving
handheld
This message indicates that a new folder has been created to contain the
transmitted document.
Receiving
handheld
This message indicates that the cable is not correctly attached to the
receiving handheld's link port. Remove the cable then reattach it and try the
transmission again.
Click OK to cancel the transmission message.
"Transfer failed. Check cable and try again."
"<folder>/<filename(x)> received."
"<new folder>/<new filename> received."
"Transfer failed. Check cable and try again."
OK
transfer."
OK
OK
Connecting Handhelds and Transferring Files 77