Simulation - Dennerle Trocal LED Control Quick Start

Quick start:
Trocal LED Control & GHL Control Center

4. Simulation

Under this menu item you can set the period of the active moon phase simulation. This moon phase
simulation does not "create" any moonlight, it influences the curve for the moonlight programmed in
the illumination channel. The moonlight now corresponds to the current natural moon phases.
Accordingly, at new moon e.g., no moonlight can be identified.
4.1 In the sidebar, select "Simulation".
4.2 Select the start time and the end time in
which the moon phase simulation should
be active.
Ideally, this period of time corresponds to
the setting curve for the moonlight in the
illumination run.
4.3 To save the moonlight run, click
The settings made are transferred to the
device.
4.4 For activating the moonlight you must
select the check box "Depends on moon
phase" in the corresponding illumination
channel.
in the menu.
Page 5 of 5