Armrest, Foldable And Removable - Invacare Action 4 NG Series User Manual

Adjusting the armpad height
1. Loosen the screw B with 5 mm Allen key at top of the
armrest tube.
2. Move the armrest upwards or downwards until you
reach the desired height, while keeping screw B in
place.
3. Tighten the screw B (5–6 Nm).
4. Perform the setting on both sides.
Adjusting the armpad depth
1. Loosen the 2 screws C below the armrest bracket.
2. Move the armrest frontwards or rearwards until you
reach the desired depth, while keeping screw C in
place.
3. Tighten the 2 screws C (1,5–2 Nm).
4. Perform the setting on both sides.
Adjusting the side protection height
1. Loosen the 2 screws of the side protection clamps D.
2. Move the side protection upwards or downwards until
you reach the desired height.
3. Tighten the 2 screws of the side protect clamps D
(0,7–1,2 Nm).
4. Perform the setting on both sides.
1608637-E

3.7.4 Armrest, foldable and removable

Folding
1. Grip the armrest by the armpad or by the front curve
and fold it back.
Front removing
1. Press and hold the armrest release push pin A at the
front.
2. Remove armrest from armrest socket by pulling straight
up and fold it back.
Front fitting
1. Push the armrest down and until the front release
button B snaps into its armrest socket hole.
2. Ensure button protrudes fully through socket hole.
Rear removing
1. Remove armrest from armrest bracket D by pulling
straight up on the armrest.
Product Overview
23