Product Description And Specifications; Intended Use; Product Features; Tool Specifications - Würth EMS 12-A Translation Of The Original Operating Instructions

OBJ_BUCH-1106-003.book Page 14 Thursday, October 27, 2016 2:00 PM
 In case of damage and improper use of the
battery, vapours may be emitted. Ventilate
the area and seek medical help in case of com-
plaints. The vapours can irritate the respiratory system.
 Use the battery only in conjunction with your
Würth power tool. This measure alone protects the
battery against dangerous overload.
 The battery can be damaged by pointed
objects such as nails or screwdrivers or by
force applied externally. An internal short circuit
can occur and the battery can burn, smoke, explode or
overheat.
 Wear protective gloves when changing appli-
cation tools/accessories. Application tools/acces-
sories become hot after prolonged usage.
 Do not scrape wetted materials (e.g. wallpa-
per) or on moist surfaces. Penetration of water into
the machine increases the risk of an electric shock.
 Do not treat the surface to be worked with sol-
vent-containing fluids. Materials being warmed up
by the scraping can cause toxic vapours to develop.
 Exercise extreme caution when handling the
scraper. The accessory is very sharp; danger of injury.
 Use only original Würth accessories.

Product Description and Specifications

Read all safety warnings and all
instructions. Failure to follow the warnings
and instructions may result in electric shock, fire
and/or serious injury.
While reading the operating instructions, unfold the graphics
page for the machine and leave it open.

Intended Use

The machine is intended for sawing and cutting wooden mate-
rials, plastic, gypsum, non-ferrous metals and fastening ele-
ments (e. g. nails, staples). It is also suitable for dry sanding
and scraping of small surfaces. It is especially suitable for
working close to edges and for flush cutting.
For damage caused by usage other than intended, the user is
responsible.

Product Features

While reading the operating instructions, unfold the graphics
page for the machine and leave it open.
The numbering of the product features refers to the illustration
of the power tool on the graphics page.
1 Battery unlocking button
2 Battery pack
3 Button for charge-control indicator
4 Battery charge-control indicator
5 On/Off switch
6 Thumbwheel for orbit frequency preselection
7 Venting slots
8 Tool holder
9 Handle (insulated gripping surface)
10 Sanding plate
11 Clamping bolt with spring washer
12 Hex key
13 Sanding sheet*
14 Adapter for tool holder
15 Saw blade*
*Some accessories shown or described are not part of
the standard delivery scope of the product.

Tool Specifications

Cordless Multi Cutter
Art. No.
Rated voltage
No-load speed n
0
Oscillation angle, left/right
Weight according to
EPTA-Procedure 01:2014
Permitted ambient temperature
– during charging
2)
– during operation and
during storage
Recommended batteries
Recommended chargers
1) depending on the battery pack being used
2) limited performance at temperatures <0 °C
EMS 12-A
5700 105 X
V= 12.0
-1
min 5000–20000
° 1.4
1)
kg 0.97–1.2
°C 0...+45
°C –20...+50
AKKU-LI 12V/x,x Ah
AL 30-LI
14