Vaisala MD30 Setup Manual page 4

Setup Guide
2
Spreader Preparations and Wirinng System Type 1 Setup: MD30 and Vaisala RoadAI (with phone)
Cabling Bluetooth Module Enclosure
Select a suitable location for the Bluetooth module enclosure in the vehicle cabin.
1
Open the enclosure by removing the 4 screws and the lid.
2
Route the extension cable from the mobile sensor towards the Bluetooth module enclosure.
3
Connect the extension cable wires in the Bluetooth module enclosure as shown.
4
Vehicle power
outlet
12 ... 32 VDC
Connect last!
Splitter
(optional)
Route the power cable from the Bluetooth module enclosure next to the vehicle power
5
outlet and connect it. If you use a splitter, connect that first. You can use the existing
plug or unscrew the plug, strip the cable and connect the wires.
Attach the lid to the enclosure. Tighten the cable glands. Attach the enclosure to a
6
suitable location in the vehicle cabin using adhesive tape or other fasteners. Secure the
MD30 cable and connector to the vehicle with cable ties.
Configuring Phone
If you have not set up the RoadAI phone app,
1
go to setup.vaisala.ai
the instructions. Check also that you have
the email from Vaisala RoadAI Support that
you have received earlier.
When done, make sure that the phone is
2
showing the following.
Bluetooth
module enclosure
Power cable
Extension cable
8 m (26 ft)
on the web and follow
North America version
EMEA/APAC version
4