Assistance Or Service - Maytag 3RMED4905TW0 Use & Care Manual Installation Instructions

Hide thumbs Also See for 3RMED4905TW0:
Table of Contents

Advertisement

Available languages

Available languages

WARNING
Explosion Hazard
Keep flammable materials and vapors, such as petrol,
away from dryer.
Place dryer at least 46 cm (18 inches) above the floor
for a garage installation.
Failure to do so can result in death, explosion, or fire.
Is the dryer located in a room with temperature below 7ºC (45ºF)?
Proper operation of dryer cycles requires temperatures above 7ºC (45ºF).
Is the dryer located in a closet?
Closet doors must have ventilation openings at the top and bottom of the door. Sides and
front of dryer require a minimum of 2.5 cm (1") of airspace, and the rear of the dryer
requires 12.7 cm (5"). See the Installation Instructions.
Has an air dry cycle been selected?
Select the right cycle for the types of garments being dried.
Is the load too large and heavy to dry quickly?
Separate the load to tumble freely.
Cycle time too short
Is the automatic cycle ending early?
Change the dryness level setting on Automatic Cycles. Increasing or decreasing the
dryness level will change the amount of drying time in a cycle.
Lint on load
Is the lint screen clogged?
Lint screen should be cleaned before each load.
Stains on load or drum
Was dryer fabric softener properly used?
Add dryer fabric softener sheets at the beginning of the cycle. Fabric softener sheets added
to a partially dried load can stain your garments.
Drum stains are caused by dyes in clothing (usually blue jeans). This will not transfer to
other clothing.
Loads are wrinkled
Was the load removed from dryer at the end of the cycle?
Was the dryer overloaded?
Dry smaller loads that can tumble freely.
Odors
Have you recently been painting, staining or varnishing in the area where your dryer is
located?
If so, ventilate the area. When the odors or fumes are gone from the area, rewash and dry
the clothing.
Is the dryer being used for the first time?
The new electric heating element may have an odor. The odor will be gone after the first
cycle.

ASSISTANCE OR SERVICE

Before calling for assistance or service, please check "Troubleshooting." It may save you the
cost of a service call. If you still need help, contact the dealer from whom you purchased the
range, or a Maytag designated service company.
When calling, please know the purchase date and the complete model and serial number of
your appliance. This information will help us to better respond to your request.
21

Advertisement

Table of Contents
loading

This manual is also suitable for:

3rmed4905tw13rmed4905tw2

Table of Contents