Electrolux Kelvinator KSV Series User Manual page 20

USING THE REMOTE CONTROLLER
Setting the clock
AUTO
CLOCK SET TEMP.
C
FAN SPEED
FAN
SWING
TIMER
SLEEP CLOCK CANCEL
SPARE
AIM LED
CLOCK
CAUTIONS
Static electricity or other factors (in case of extremely high voltage) can
cause remote controller clock initialize. If your remote controller is
initialized (flashing 0:00"), readjust the clock before you start operation.
Before you start operating the air conditioner,
set the clock of the remote controller using
the procedures given in this section. The
clock panel on the remote controller will
display the time regardless of whether the
air conditioner is in use or not.
Initial Setting or the Clock
After batteries are inserted in the remote
controller, the clock panel will display "0:00"
and begin to flash.
1. TEMP/TIME adjust button
Press this button to set time.
.
Forward.
Backward.
2
Each time you press the button, the time
.
moves forward or backward by one minute
depending on which side you press.
The time alters as quickly as you push the
button.
Keep pressing the button without releasing,
.
the time moves forward or backward by 10
minutes depending on which side you press.
2.
CLOCK button
When the right time is achieved, press the
CLOCK button or release the
wait for 5 seconds, the clock time stops
flashing and the clock starts operating.
3.Readjusting the Clock
Press the CLOCK button on the remote
controller for about 3 seconds, the colon in
the clock display will start to flash.
To set the new time, follow 1 and 2 of "Initial
Setting of the Clock".
Note: The time of the CLOCK must be set
before the AUTO-TIMER feature will operate.
If you readjust the time of the CLOCK after
setting the AUTO-ON/OFF timer, the remote
controller will send the readjusted timer
information to the unit.
* Clock accuracy is within 15 seconds per day.
"
or and
19