Startup / Operation - BOMANN DTE 236 Instruction Manual

Household- built-in double door refrigerator

Hide thumbs

Table Of Contents

Table of Contents

Available languages

Screw the appliance door with the furniture door

NOTE: : : :

NOTE

Follow below instruction for connecting the furniture door with the freezer and fridge appliance door.

Hold the rail guides (A) at the top and bottom of the

inside furniture door and mark the positions of the drill

holes. Keep a distance of 50 mm from the upper edge

or lower edge of the furniture door and the distance of

20 mm from the door outer edge. Attach the guides with

the accompanying screws ST 4 x 12 mm.

If an aligning of the furniture door is necessary, use the

slot space. Check that the door is aligned vertically and

horizontally, so that a smooth opening and closing of

the door is ensured.

Prior to first use

CAUTION: : : :

CAUTION

After transport, the appliance should be left standing for approx. four hours before connecting to the power

supply. Nonobservance could lead to malfunction of the cooling system and causes a breakdown of the appli-

ance.

Clean the interior of the appliance including all accessory parts located inside. Consider the instructions which

we provide in the chapter "Cleaning and Maintenance".

Starting the appliance

• Connect the appliance to the power supply;

• operate the temperature control, which is located in the fridge interior. See also the following section "Set-

tings".

Open the appliance and furniture door completely and

lead them together. Slide the bracket (B) into the guide

(A) and draw in the drill holes. Remove the bracket (B)

and drill holes with Ø 2 mm to about 8 mm distance

from the door edge. Set the bracket (B) back to the

guide (A) and secure it with the supplied screws ST 4 x

12 mm.

Install the cover (D) into the guide (B) until it locks.