Installation - BOMANN DTE 236 Instruction Manual

Household- built-in double door refrigerator

Table of Contents

Available languages

Conditions for the installation location

• Good ventilation is required around the appliance, in order to dissipate the heat properly and to guarantee

efficient cooling operation at low power consumption. For this purpose, sufficient space around the appli-

ance must be present, see also "Built-in". Clearance in front of the appliance must be created so that the

appliance door can open without being impeded.

• Only install at a location with an ambient temperature suitable for the climate class of the appliance. For

information on the climate class, please refer to chapter "Technical Data" or to the rating label located in

the appliance interior or rear side.

• Place the appliance only on a steady and safe surface.

• Avoid the installation:

Avoid the installation:

near heaters, next to a stove, direct sunlight or any other heat sources;

at locations with high humidity (e.g. outdoors, bathroom), as metal parts would be susceptible to cor-

rosion under such circumstances;

near volatile or flammable materials (e.g. gas, fuel, alcohol, paint, etc.) and in rooms which may have

poor air circulation (e.g. garages).

Electrical connection

WARNING:

• The installation to the mains supply must conform to the local standards and regulations.

• Improper connection may cause to an electric shock

• Do not modify the appliance plug. If the plug does not fit properly to the outlet, let install a proper outlet by

an authorized specialist.

• The accessibility of the power plug must be ensured in order to disconnect the appliance from the power

supply in case of an emergency.

CAUTION

CAUTION: : : :

CAUTION

In case you disconnect the appliance or in case of power failure:

- Wait for approx. 5 minutes before restarting the appliance.

- Check the operation settings.

• Ensure that your mains power corresponds with the specifications of the appliance. The specifications are

printed on the rating label.

• Connect the mains cable to a properly installed and earthed wall outlet.

Installation

electric shock!

electric shock

Table of Contents