AOR AR2300 Operating Manual page 4

SAFETY PRECAUTIONS
DO NOT operate the receiver near unshielded electrical blasting caps or in an explosive atmosphere. This could cause
an explosion and death.
DO NOT operate the receiver with a headset or other audio accessories at high volume levels. If you experience a
ringing in your ears, reduce the volume or discontinue use.
DO NOT directly apply AC power to the DC socket on the receiver rear panel. This could cause a fire or damage the
receiver.
DO NOT apply more than 16 V to the DC socket on the receiver rear panel. This could cause a fire or damage the
receiver.
DO NOT reverse the DC power cable polarity. This could cause a fire or damage the receiver.
DO NOT let metal, wire or other objects contact the inside of the receiver, or make incorrect contact with connectors
on the rear panel. This could cause an electric shock or damage the receiver.
DO NOT operate or touch the receiver with wet hands. This could cause an electric shock or damage to the receiver.
Immediately turn OFF the receiver power and remove the power cable from the receiver if it emits an abnormal odor,
sound or smoke. Contact your AOR dealer or distributor for advice.
DO NOT put the receiver on an unstable place where the receiver may suddenly move or fall. This could cause an injury
or damage the receiver.
DO NOT operate the receiver during a lightning storm. It may result in an electric shock, cause a fire or damage the
receiver. Always disconnect the power source and antenna before a storm.
DO NOT expose the receiver to rain, snow or any liquids.
DO NOT change the internal settings of the receiver. This could reduce receiver performance and / or damage the
receiver. The receiver warranty does not cover any problems caused by unauthorized internal adjustments.
DO NOT install or place the receiver in a place without adequate ventilation.
DO NOT use harsh solvents such as Benzine or alcohol when cleaning, as they will damage the receiver surfaces.
DO NOT leave the receiver in areas with temperatures below 0°C or above +50°C.
DO NOT place the receiver in excessively dusty environments. This could damage the receiver.
DO NOT place the receiver against walls or put anything on top of the receiver. This may overheat the receiver. The
receiver will become hot when operating the receiver continuously for long periods of time.
Turn OFF the receiver's power and / or disconnect the DC power cable when you will not use the receiver for a long
period of time.
The AR2300 may receive its own oscillated frequency, resulting in no reception or only noise reception including on the
spectrum displayed by control software, on some frequencies.
2