Pittsburgh Automotive 60234 Owner's Manual & Safety Instructions page 3

Setup
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Note: For additional information regarding the parts listed in the following pages,
refer to Parts List and Diagram on page 7.
Assembly
1. Connect a Support (41) to each corner of the
Saddle (32) using a Bolt (39) and Washer (40).
2. Thread a Wing Nut (37) onto the threaded end of
the Chain Hook (38) with its wings facing the hook.
3. Slide a Washer (31) onto the threaded
end of the Chain Hook.
4. Insert the threaded end of the Chain Hook through
the hole on the bracket on the Saddle, as shown.
5. Secure the Chain Hook to the Saddle's bracket
using Washer (31) and Wing Nut (37).
Checking/Filling Hydraulic Fluid
IMPORTANT! Before first use:
1. Remove the Oil Fill Plug.
2. Check hydraulic oil level and fill to 1/4"
below the fill port as needed.
3. Replace the Oil Fill Plug.
4. Thoroughly test the Jack for proper operation.
If it does not work properly, bleed air from its
hydraulic system as described in Bleeding, below.
Bleeding
1. Follow the Checking/Filling Hydraulic Fluid
instructions above.
2. Turn the Release Valve counterclockwise to open it.
3. Pump the Handle up and down quickly several
times to purge air from the system.
60234
TO PREVENT SERIOUS INJURY:
Remove load from the jack before any procedure on this page.
For technical questions, please call 1-888-866-5797.
Bolt (39)
Washer (40)
Support (41)
Saddle
(32)
Figure A: Assembly
Oil Fill
Plug
Figure B: Hydraulic Fluid Service Parts
4. Check hydraulic oil level and fill to
1/4" below the fill port as needed.
5. Replace the Oil Fill Plug and close the
Release Valve by turning it clockwise.
Chain
Hook (38)
Wing
Nut (37)
Washer (31)
Washer (31)
Wing
Nut (37)
Handle
Release
Valve
Page 3