Specifications; Important Safety Information - Pittsburgh Automotive 60234 Owner's Manual & Safety Instructions

Specifications

Weight Capacity 800 lb.
Tilt 55º forward, 8º back, 30º side

IMPORTANT SAFETY INFORMATION

Read all safety warnings and instructions.
Save all warnings and instructions for future reference.
Failure to heed these markings may result in personal injury and/or property damage:
1. Study, understand, and follow all instructions
before operating this device.
2. Do not exceed 800 lb. rated capacity.
3. Use only on hard, level surfaces.
4. Adequately support the vehicle
before starting repairs.
5. Use of this product is limited to the removal,
installation, and transportation in the lowered position,
of transmissions, transfer cases, and transaxles.
6. Do not adjust safety valve.
7. Wear ANSI-approved safety goggles and
heavy-duty work gloves during use.
Page 2
WARNING SYMBOLS AND DEFINITIONS
This is the safety alert symbol. It is used to alert you to potential personal injury hazards.
Obey all safety messages that follow this symbol to avoid possible injury or death.
Indicates a hazardous situation which, if not avoided,
Indicates a hazardous situation which, if not avoided,
Indicates a hazardous situation which, if not avoided,
Addresses practices not related to personal injury.
SAVE THESE INSTRUCTIONS.
For technical questions, please call 1-888-866-5797.
Maximum Height 22-1/2"
Minimum Height
will result in death or serious injury.
could result in death or serious injury.
could result in minor or moderate injury.
8. Keep clear of load while lifting and lowering.
9. Lower load slowly.
10. Do not use for aircraft purposes.
11. Inspect before every use;
do not use if parts loose or damaged.
12. Do not alter the jack or use attachments and/or
adapters that are not supplied by the manufacturer.
13. The warnings, precautions, and instructions
discussed in this manual cannot cover all
possible conditions and situations that may occur.
The operator must understand that common sense
and caution are factors, which cannot be built into
this product, but must be supplied by the operator.
8-1/2"
60234