Advertisement
ASSEMBLE HOPPER PANEL (J) & LEGS (G) TO CABINET (FIG 4)
• Turn the Cabinet Assembly upside down and apply Sealing
Foam (MM) to the exposed fl ange surfaces.
• Place the Hopper Panel (J) (with funnel outlet upward) against
the Cabinet Assembly trapping the Sealing Foam between.
• Set the (4) Legs (G) with fl anges against the fl at surfaces of
the Hopper Panel.
• Secure above components with (20) M6 x 12mm screws (AA)
and nuts (EE). Tighten all hardware.
4 Pcs.
MM Sealing Foam, 3mm
20 Pcs. AA
20 Pcs. EE
INSTALL AIR FILTER (FIG 5)
• Turn the Cabinet Assembly right side up and resting
on the Legs.
• Place the Air Filter (O) (with conical shape facing inward) over
the hole in the Right Side Cabinet Side Panel (E) and secure
in place with the Filter Retaining Ring (P) and (4) M4 x 20mm
screws (BB), nuts (FF) and fl at washers (GG) (FIG 5A).
3 Pcs.
BB
3 Pcs.
GG
3 Pcs.
FF
INSTALL LATCH & LAMP CLAMPS (FIG 5)
• Place the Latch (M) (with "hook" portion oriented upwards)
over the holes in the Cabinet Front Panel (D) and secure
in place with (2) M4 x 10mm screws (CC), nuts (FF) and
fl at washers (GG).
• Locate 2 holes in the upper area of the Rear Cabinet Panel
(B) and secure the (2) Lamp Clamps (JJ) with (2) M4 x 6mm
screws (DD), nuts (FF) and Flat Washers (GG).
4 Pcs.
CC
2 Pcs.
DD
6 Pcs.
GG
6 Pcs.
FF
To order parts and supplies: 800.345.1178 >> eastwood.com
M6 x 12mm Screw
M6 Nut
M4 x 20mm Screw
M4 Flat Washer
M4 Nut
M4 x 10mm Screw
M4 x 6mm Screw
M4 Flat Washer
M4 Nut
FIG. 4
FIG. 4
G
FIG. 5
FIG. 5
JJ
D
M
FIG. 5A
FIG. 5A
J
O
P
B
E
O
P
MM
5
Advertisement
