Advertisement
ASSEMBLY
APPLY SEALING FOAM (FIG 1)
Peel away protective paper and apply Sealing Foam (MM) on
the outer, short-side fl anged surfaces of the Front Panel (D),
and along the outer short-side end fl ange surfaces of the
2 Side Panels (C+E).
4 Pcs.
MM Sealing Foam, 3mm
ASSEMBLE CABINET PANELS (B), (C), (D) & (E) (FIG 2)
Trapping the Sealing foam between panels, assemble the
Rear Panel (B) with baffl e at the upper left to the 2 Side Panels
(C+E) and to the Front Panel (D) with fl anges all facing inward
then attach with (12) M6 x 12 screws (AA) and M6 nuts (EE).
Do not fully tighten hardware at this point
12 Pcs. AA
12 Pcs. EE
INSTALL CORNER REINFORCEMENTS (N) (FIG 3)
• Peel away protective paper and apply Sealing Foam (MM) to
the upper surfaces of the (4) Corner Braces (N).
• Install (4) Corner Braces (N) to the upper underside corners of
the Cabinet Assembly with (8) M4 x 10mm screws (CC) and
nuts (FF) trapping the Sealing Foam between Corner Braces
and panel fl anges. (Fully tighten all screws
at this time).
• It is recommended to put a dab of silicone or RTV in the corners
of joints to prevent air or media leaks.
4 Pcs.
MM Sealing Foam, 3mm
8 Pcs.
CC
4
M6 x 12mm Screw
M6 Nut
M4 x 10mm Screw
FIG. 1
FIG. 1
D
MM
C
MM
FIG. 2
FIG. 2
B
C
FIG. 3
FIG. 3
Dab of Silicone
or RTV
Eastwood Technical Assistance: 800.544.5118 >> techelp@eastwood.com
MM
MM
E
E
D
Dab of Silicone
or RTV
N
Advertisement
