Table of Contents
Advertisement
Positioning
The tumble dryer can be positioned on any firm
level surface. Check that it is absolutely level
with the aid of a spirit level. If it is not, raise or
lower the feet until it is.
Air must be able to circulate freely all round the
appliance. Do not obstruct the front ventilation
grille or the air intake grilles at the back of the
machine.
The feet must never be removed.
Do not restrict the floor clearance through
deep-pile carpets, strips of wood or similar.
This might cause heat build-up which would
interfere with the operation of the appliance.
Important
The hot air emitted by the tumble dryer can reach
temperatures of up to 60°C. The appliance must
therefore not be installed on floors which are not
resistant to high temperatures.
When operating the tumble dryer, the room
temperature must not exceed 35°C, as it may
affect the performance of the appliance.
The tumble dryer must be installed in a clean
place, where dirt does not build up.
Electrical connection
This machine is designed to operate on a 220-
230 V, single-phase, 50 Hz supply.
Check that your domestic electrical installation
can take the maximum load required (2.2 kW),
also taking into account any other appliances in
use.
Connect the machine to an earthed socket, in
accordance with current wiring regulations.
The manufacturer declines any
responsibility for damage or injury
through failure to comply with the
above safety precaution.
6
INSTALLATION
Stacking kit
It is possible to mount the dryer on top of all
washing machines having a worktop 60 cm wide
and a front loading. To this purpose, the special
stacking kit is available through your dealer.
Complete installation instructions are enclosed
with the kit.
P1044
Connecting a drain hose
If there is a sink or drain near the appliance, the
condensed water can be discharged directly
through a hose that is available on the market.
In order to connect the hose to the appliance
proceed as follows:
Remove the clamp (A)
Pull out the plug (B)
Insert the drain hose (C)
Fasten the hose (C) to the appliance using the
clamp (A).
P1043
If the appliance is stacked on the washing
machine, the condensed water can be
discharged through the hose as shown in figure,
but take into account that the hose must be
pointed downwards.
P1046
A
B
A
B
C
C
Hide quick links:
Advertisement
Table of Contents
