Before Applying Pow Er; Safety Precautions - Kenwood XD-750 Instruction Manual

Before applying pow er

2
Units are designed for operation as follow s.
Europe and U.K. ........................................................................ AC 230 V only
For the United Kingdom
Factory fitted moulded mains plug
1.The mains plug contains a fuse. For replacement, use only a 13-
Amp ASTA-approved (BS1362) fuse.
2.The fuse cover must be refitted w hen replacing the fuse in the
moulded plug.
3.Do not cut off the mains plug from this equipment. If the plug
fitted is not suitable for the pow er points in your home or the ca-
ble is too short to reach a pow er point, then obtain an appropriate
safety approved extension lead or adapter, or consult your dealer.
If nonetheless the mains plug is cut off, remove the fuse and dis-
pose of the plug immediately, to avoid a possible shock hazard by
inadvertent connection to the mains supply.
IM PORTANT: The w ires in the mains lead are coloured in accord-
ance w ith the follow ing code:
Blue
Brow n : Live
Do not connect those leads to the earth terminal of a three-pin
plug.

Safety precautions

WARNING : TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO
RAIN OR M OISTURE.
RISK OF ELECTRIC SHOCK
REQUIREM ENT BY NEDERLAND GAZETTE
Batteries are supplied w ith this product. When
they empty, you should not throw aw ay. Instead,
hand them in as small chemical w aste.
Downloaded from: http://www.usersmanualguide.com/
: Neutral
CAUTION
DO NOT OPEN
THE LIGHTNING FLASH WITH ARROWHEAD SYM BOL, WITHIN AN EQUILATERAL TRIANGLE, IS INTENDED
TO ALERT THE USER TO THE PRESENCE OF UNINSULATED " DANGEROUS VOLTAGE" WITHIN THE
PRODUCT'S ENCLOSURE THAT M AY BE OF SUFFICIENT M AGNITUDE TO CONSTITUTE A RISK OF ELEC-
TRIC SHOCK TO PERSONS.
THE EXCLAM ATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER TO
THE PRESENCE OF IM PORTANT OPERATING AND M AINTENANCE (SERVICING) INSTRUCTIONS IN THE
LITERATURE ACCOM PANYING THE APPLIANCE.
Caution : Read this page carefully to ensure safe operation.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REM OVE COVER
(OR BACK). NO USER-SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALI-
FIED SERVICE PERSONNEL.
The marking of products using lasers
The marking is located on the rear panel and says that the compo-
nent uses laser beams that have been classified as Class 1. It means
that the unit is utilizing laser beams that are of a w eaker class. There
is no danger of hazardous radiation outside the unit.
XD-7 5 0 / 7 0 0 / 5 5 0 / 5 0 0 (En)
(Except for some areas)
CLASS 1
LASER PRODUCT