6. DOOR SWING
6.1 Change the opening direction of the
door (Indoor models)
>
Open the door
>
Remove the hinge plastic covers.
>
Support the door in the open position and use a
screwdriver to remove the screws from both hinges.
>
Do not remove the hinges from the door.
>
Remove the little caps from the upper and lower
holes of the new position and place them in the holes
on the opposite side of the unit.
>
Partially re-install screw #1 in the opposite holes of
the unit.
>
Turn the door upside down and align the hinges with
screw #1 to re-position the door.
>
Re-install screw #2 align the door and tighten all
screws securely.
>
Check that the gasket is aligned with the plastic
outline of the front of the unit.
>
Replace the plastic covers on the hinges.
52
www.fhiaba.com · info@fhiaba.com · Info Line +39 0434 420162
#1#2
#1#2