Step 1: Sensor Heads Installation - Pioneer SDA-BS900 Instruction Manual And Installation Manual

Step 1: Sensor heads Installation

Mounting Radar Pucks with Provided Adjustable Brackets:
1) Prepare Materials brackets and radar heads (see Fig 5).
2) Mount the sensor module on the bracket with screws of the assemble bag (see Fig 6).
3) After found angle is set, firmly screw or bolt the bracket to the car (see Fig 7).
Fig 5
Use Supplied Tool to Set Proper Radar Puck Angle: the default installation angle is: 38 degree.
Depending on actual situation, the install angle could be adjusted accordingly.
Please following installation guide view to installed the sensors as below:
Two sensors will respectively installed the vehicle rear left and right corner parts, in the bumper
(see Fig 8).
Height of sensor installation should be between the lowest line of tail lights and the highest line
of fog lights (see Fig 9).
Top view
sensor
38°
Launch
direction
Please see illustration below, for correct guidance and mounting position of sensors with angle tool
(see Fig 10, Fig 11).
Note: Place the flat side of angle tool on the front of the sensor head, align the arrow of the angle tool
to point towards the back of the vehicle ( see Fig10, Fig 11).
Front
sensor
Rear
38°
Car direction
Launch
direction
Fig 8
Fig 6
Side view
Tail light
The lowest line
of tail lights
The highest line
of fog lights
Fog light
-11-
Fig 7
Fig 9