Table of Contents
Advertisement
1
1
(
ORIGINALS )
EVEN NUMBER
ODD NUMBER
2
1
4
7
AUDIT
0 /
CLEAR
ODD NUMBER
2
2
PRE-COUNT
ORIGINAL
Downloaded from:
http://www.usersmanualguide.com/
2
EVEN NUMBER
ODD NUMBER
2
2
1
1
2
PRE-COUNT
STAPLE
ORIGINAL
SORT
3
2
5
6
START
8
2
EVEN NUMBER
ODD NUMBER
1
1
2
2
1
1
2
PRE-COUNT
STAPLE
ORIGINAL
SORT
I
I
If the number of originals is known, use the ORIGINAL
2
TO COPY key to select EVEN NUMBER or ODD
NUMBER on the ORIGINAL TO COPY section of the
operation panel, then proceed to step 3. If the number
of originals is not known, select PRE-COUNT
ORIGINAL for an automatic count by the RADF and
press the START key.
The following message will appear.
<M057A>
THE NUMBER OF ORIGINALS IS --.
When the count is complete and the number is known, replace
the originals in the RADF tray and select EVEN NUMBER or
ODD NUMBER as above.
Enter the desired number of copies.
3
If the specified number of copies is more than 50, the COPIES
SELECTED display will display 50 after starting copying. If an
optional sorter is installed, the display will change to 20 after
copying starts. (in sort mode)
Press the START key.
4
To cancel a copy run during duplex copying, press the CLEAR
ALL key. Incomplete copies will be output from the duplex tray.
2-sided copies from 2-sided originals
Set the originals face down in the RADF tray and adjust
1
the original guides to the size of the originals.
Use the ORIGINAL TO COPY key to select
2
USING THE RADF
2
.
2
13
Advertisement
Table of Contents
