Quantum 4000 Installation And Operation Manual page 21

Table 2-4 Front Panel Indicators and Controls
2-line by 20-character
LCD Display
Beeper
Write Protected
(orange)
Tape in Use
(yellow)
Use Cleaning Tape
(yellow)
Operate Handle
(green)
Density Select 2.6
(yellow)
Density Select 6.0
(yellow)
Density Select 10.0
(yellow)
Density Select 20.0
(yellow) [4000DLT
only]
Density Select 70.0
(yellow) [7000DLT
only]
Compress
(yellow)
Density Override
(yellow)
Unload Button
Cartridge Insert/
Release Handle
Displays drive status, error messages, POST results
Sounds whenever it is OK to operate the cartridge insert/
release handle. The green Operate Handle LED should be
ON whenever the Beeper sounds.
ON = Tape write-protected.
OFF = Tape write enabled.
Blinking = Tape moving.
ON = Tape loaded; ready for use.
ON = Drive head needs cleaning, or the tape is bad.
OFF = cleaning complete, or cleaning unnecessary.
ON = OK to operate the cartridge insert/release handle.
OFF = Do not operate the cartridge insert/release handle.
ON = Tape is recorded in 2.6 GB format.
Blinking = Tape is recorded in another density.
ON = Tape is recorded in 6.0 GB format.
Blinking = Tape is recorded in another density.
ON = Tape is recorded in 10.0 GB format.
Blinking = Tape is recorded in another density.
ON = Tape is recorded in 20.0 GB format.
Blinking = Tape is recorded in another density.
ON = Tape is recorded in 70.0 GB format.
Blinking = Tape is recorded in another density
ON = Compression mode enabled.
OFF = Compression mode disabled.
ON = Density selected from front panel.
OFF (default) = Density selected from host.
Blinking = In density selection mode.
Pressing this button initiates a manual unload of the tape.
This may take from 10 seconds to 4 minutes depending on
tape position.
Lift this handle (only when the Operate Handle LED is ON,
and after the momentary beep sounds) to load or eject a
cartridge from the drive. The handle lifts to the open
position and lowers to the closed position.
Description 2-7