Yamaha YP250A 1999 Supplementary Service Manual page 79

ANTI-LOCK BRAKE SYSTEM (ABS)
Replacing the wheel sensor rotor
Wheel sensor rotor of YP250A is pressed in by the
special process and cannot be replaced as a
single unit. To replace the sensor rotor, replace as
a wheel assembly.
Assembling the rear wheel sensor
1. Install:
S Rear wheel sensor 1
NOTE:
When installing the wheel sensor, check if the
wheel sensor wire is twisted or foreign materials
attached to the electrode.
CAUTION:
To route the rear wheel sensor lead, refer to the
CABLE ROUTING.
2. Connect:
S Wheel sensor lead connector 1
CAUTION:
To route the rear wheel sensor wire, refer to
CABLE ROUTING.
71
CHAS
23 Nm (2.3 mSkg)